Sharp R-880D Manual de Instruções descarregar pdf (Página 5)

STP-200/300/400 Series Instruction Manual

◇ NEVER use any gas that is not specified as usable in this Manual.

The use of such gas may corrode the STP pump and damage it.

◇ Always check the STP pump has stopped, then turn OFF the primary

power (Switch the breaker "OFF") before proceeding to any of the

following operations. Failure to do so may cause the STP pump to

rotate accidentally, which may injure operators seriously or result in

electric shock.

•

Connect or disconnect cables;

•

Connect an external battery;

•

Perform maintenance and inspections such as replacement of the

internal battery and/or fuses as well as inspections of deposit

and/or the air cooling fan; or

•

Perform investigations into probable causes and action/measures

taken in the event of occurrence of a problem.

◇ The STP control unit is a heavy product. Always use a crane or the

like when lifting it. Failure to do so may damage your hipbone or

injure you due to occurrence of an accident such as fall.

◇ Install the STP control unit not only by fitting it with the front panel

fitting screws but also by supporting it from the bottom side. Fitting

the STP control unit with the screws only cannot sustain its weight,

and therefore resulting in product damage.

◇ Always use the STP pump, STP control unit and STP connection

cables of the same model name, serial number and cable length,

which are specified on their own name plate. Failure to do so may

result in product damage. If you plan to use the units with the same

model name but different serial numbers and cable length; they must

be adjusted. If the model names are different, they may not be used

even when performing adjustment. In both cases, contact BOC

Edwards.

1 2 3 4 5 6 7 8 9 10 ... 129 130

Sem comentários

Sharp R-880D Manual de Instruções Página 5