Sharp R-440/540 Manual do Operador descarregar pdf (Página 79)

918496/GP0313 71

b. Perform the “Mandatory Safety

Shutdown Procedure” on page 10.

c. Remove a spring pin (A, Fig. 30)

from the end of the lift arm lock

bar (B). Remove lift arm lock bar

(B) from the storage bracket.

d. Slide the lock bar (B) all the way

through holes (C, Fig. 30) in the

lift arm and holes (D) in the tilt

pivot arm.

e. Replace the spring pin (A) into the

end of the lock bar (B).

Important: Lock bar (B) must

pass all the way through holes (C)

in the lift arm and holes (D) in the

tilt pivot arm, with spring pins (A)

installed in lock bar (B) on

outsides of the lift arm.

4. On AL 200 and AL 300 Series machines:

a. If necessary, raise the lift arm to allow for down-stop lock bar (A, Fig. 29)

removal.

b. Remove spring pins (A) from both ends of the down-stop lock bar (B).

Remove lift arm lock bar (B) from the machine.

c. Lower the lift arm all the way. Tilt the attachment hitch all the way back.

Note: Holes (C) in the frame, in the lift arm and holes (D) in the tilt pivot

arm must align to allow down-stop lock bar (A) to pass completely

through all the holes.

Figure 27 – 100 Series Lift Arm

Tilt Lock

Figure 28 – AL 100 Series Lift

Arm Lock Bar Storage

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 179 180

Sem comentários

Sharp R-440/540 Manual do Operador Página 79