Sharp R-440/540 Manual do Operador descarregar pdf (Página 148)

140 918496/GP0313

Drive Control Module Error Codes

Malfunctioning drive function may indicate a control module error condition.

The table on page 140 describes control module error codes. Error codes are

indicated by flashing LEDs (Z, Fig. 110) located near the electrical connectors at

the bottom of the module.

The LED flash pattern for error messages starts with four medium-length flashes,

which signal the start of the message, followed by a pause. After the pause, a

number of long flashes may occur, indicating the first digit for the code. After

another pause, a number of short flashes occur indicating the second digit for the

code. After a final pause, the flash pattern then repeats.

More than one error code may be displayed, one after the other.

To illustrate, the flash pattern for error code “13” would be: Four medium flashes

(message start), pause, one long flash (first digit of error code), pause, three short

flashes (second digit of error code), pause. The flash pattern then repeats.

Error Flash

Code

Description

13 Watchdog Ready Error

15 Battery Voltage or Sensor Voltage Error

19 Pump Current Forward Error

23 Pump Current Reverse Error

27 Motor Current Error

31 Engine Speed RPM Error

35 FNR Shortcut Error

39 Inching Error

43 Driving Pedal Error

47 Mode Switch-2 Error

55 Brake Pressure Defeat Error (or Parking Brake Error

or Brake Light Error)

59 Motor RPM and Direction Error

70 General CAN Receive Error

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 179 180

Sem comentários

Sharp R-440/540 Manual do Operador Página 148