Sharp R-440/540 Manual do Operador descarregar pdf (Página 20)

12 918496/GP0313

• The operator’s area, steps and hand holds must be free of oil, dirt, ice and

unsecured objects.

• If a lighting system is installed, check its operation before working in

darkness.

• Always keep lights, mirrors and windows clean. Poor visibility can cause

accidents.

• NEVER start the engine if there is any indication that maintenance or

service work is in progress, or if a warning tag is attached to the controls.

• Replace damaged safety decals and a lost or damaged operator’s manual.

• Terrain and soil conditions at the work site, approaching traffic, weather-

related hazards and any above-or below-ground obstacles and hazards

should be observed and monitored by all work crew members.

• Adjust the seat to allow full actuation of all controls. Never adjust the seat

during machine operation.

• Read the operator’s manual provided with each attachment used with the

machine before starting the engine.

• Before working on or with the machine, remove jewelry, tie back long

hair, and do not war loose-fitting garments, such as, scarves, ties,

unzipped jackets, etc., which could become caught in the moving parts of

the machine and cause injury.

During Operation

• ALWAYS fasten the seat belt securely and properly. Never operate the

machine without the seat belt fastened around the operator.

• Check indicators and displays for normal conditions after starting the

engine. Listen for unusual sounds and remain alert for other potentially

hazardous conditions.

• Control the machine cautiously and gradually until fully familiar with all

the controls and handling.

• Do not overload the machine. See weights and capacities information

starting on page 33 for the load limits.

• If the machine is equipped with a 2-post ROPS, do not overfill the

attachment and lift loads higher than the operator’s head. Objects can fall

out of the attachment and roll down the lift arm toward the operator

causing severe injury. Install a a Falling-Object Protective Structure

(FOPS) if the machine is used to lift loads above the operator’s head.

• Do not raise or drop a loaded bucket or attachment suddenly. Abrupt

movements under load can cause serious instability.

• Check that attachments are securely fastened to the attachment hitch

before working.

• Never activate the float function with the bucket or attachment loaded or

raised, because this will cause the lift arm to lower or bucket to dump

rapidly.

• Never operate the machine without a ROPS or FOPS installed.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 179 180

Comentários a estes Manuais

Sem comentários

Sharp R-440/540 Manual do Operador Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Micro-ondas Sharp R-440/540