Sharp R-440/540 Manual do Operador descarregar pdf (Página 133)

918496/GP0313 125

Planetary Axles

Changing Planetary Axle Oil

Replace the oil in the axles if it becomes contaminated, after the first 500 hours

of service, and every 1500 hours or annually thereafter.

1. Warm the axles to operating temperature.

2. Perform the “Mandatory Safety Shutdown Procedure” on page 10. The

machine must be parked on a level surface.

3. Complete the following procedures as appropriate for the model machine.

Changing Axle Wheel-Hub Oil (AL 500, AL 400 and AL 300 Series)

Note: Removing the tires and raising the machine on jackstands can make hub oil

changing easier.

1. Rotate the oil drain/fill plugs (A, Fig.

94) on the wheel hubs so they are

positioned at the top as shown in the

figure. Thoroughly clean the area

around the plugs and slowly loosen

and remove the plugs.

2. Position a waste oil collection contain-

ers, capacity 0.5 liters (0.5 quarts)

each, underneath the wheel hubs, to

catch oil as it drains.

Important: Always dispose of waste oil

according to environmental laws or take

to a recycling center for proper disposal.

DO NOT pour onto the ground or down a

drain.

3. Rotate the oil drain holes (B, Fig. 95)

on the wheel hubs so they are posi-

tioned at the bottom as shown in the

figure. Allow the oil to completely

drain from the hubs.

4. Rotate the holes on the wheel ends so

they are positioned to the side as

shown (C, Fig. 96).

5. Add oil through the holes to the level

line (D) stamped on the hub and

shown in Fig. 96. See “Fluid Capaci-

ties/Lubricants” on page 31 for the

specific oil type and grade.

Figure 94 – Wheel-Hub Oil Drain

Plug Removal Position

Figure 95 – Wheel-Hub Oil Drain

Position

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 179 180

Comentários a estes Manuais

Sem comentários

Sharp R-440/540 Manual do Operador Página 133

Comentários a estes Manuais

Manuais e produtos relacionados com Micro-ondas Sharp R-440/540