Sharp R-440/540 Manual do Operador descarregar pdf (Página 125)

918496/GP0313 117

3. Shut off the fuel supply by turning the fuel shut-off valve on top of the water

separator to OFF.

4. Remove the fuel filter.

Watch for, and catch, any fuel drips or leaks.

Wipe up spilled fuel and immediately dispose

of rags used to clean up fuel spills. Fuel vapors can ignite and cause

severe burns.

5. Clean the fuel filter gasket and the fuel filter mounting surfaces where they

contact each other with a clean cloth.

6. Lubricate new fuel filter gasket with diesel fuel.

7. Install and tighten the filter 3/4 turn past the point the where the gasket con-

tacts the filter head.

8. Turn shut-off valve on water separator to ON.

9. The engine is self-priming: to remove air from the fuel line before starting,

turn the ignition key to the ON position for 30 seconds.

Water Separator Maintenance

The water separator contains an indicator ring that floats on top of accumulated

water. Under normal conditions, this ring sits at the bottom of the separator. If the

ring is somewhere between the bottom of the separator and white ring (B, Fig.

84), then accumulated water must be drained.

Important: Water in the fuel system can cause severe engine damage. Drain

water from the fuel filter/water separator anytime water is present.

1. Perform the “Mandatory Safety Shutdown Procedure” on page 10.

2. View the water separator through the slot in front of the right-rear tire, near

the step.

3. Access the water separator from underneath the loader, near the right-rear

wheel. Check for water in water separator by checking the level of the float in

the water separator bowl. If water is present, complete steps 4-7.

4. Turn the fuel shut-off valve lever (A, Fig. 84) on the water separator to the

OFF position.

WARNING

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 179 180

Sem comentários

Sharp R-440/540 Manual do Operador Página 125