Sharp R-440/540 Manual do Operador descarregar pdf (Página 100)

92 918496/GP0313

Operating Attachments

Use only approved attachments. Contact the

Manitou Americas Service Department about

information about approved attachments. Manitou Americas cannot

be responsible for safety if the unit is used with non-approved

attachments.

Some general guidelines for attachments are included in this section. These

guidelines are not a replacement for the attachment manufacturer’s operating

instructions.

Before installing, operating and servicing attachments, carefully read the

manufacturer’s operating instructions. Contact the responsible representative for

more information.

Contact the Manitou Americas Service Department for more information about

approved attachments. Observe maximum operating load capacities. See weights

and capacities information starting on page 31.

Bucket

See “Load Handling” on page 77 for information about driving with a load.

Loading Loose Material

1. Lower the bucket and adjust the cutting edge to be parallel to the ground.

2. Drive toward the material to be loaded. Determine the correct driving speed

according to the type of material and working conditions.

3. As the cutting edge penetrates the material, raise the lift arm slightly, to load

the front axle and to minimize slipping.

Note: If the bucket has difficulties penetrating the material, use the joystick to

raise and lower the bucket.

4. Tilt back the bucket when it is full.

5. Move the bucket into transport position.

Scraping Soft Material

1. Lower the bucket onto the material.

2. Tilt the bucket forward to the desired digging angle.

3. Drive forward so that the edge of the bucket penetrates the material.

4. Reduce the forward angle to cut an even layer of material and to avoid slip-

ping.

WARNING

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 179 180

Sem comentários

Sharp R-440/540 Manual do Operador Página 100