Sharp R-440/540 Manual do Operador descarregar pdf (Página 138)

130 918496/GP0313

Lubrication

Important: Use of lubricants not corresponding to manufacturer

recommendations may invalidate warranty claims. Always dispose of waste

lubrication oils and hydraulic fluids according to environmental laws or take to a

recycling center for proper disposal. DO NOT pour fluids onto the ground or

down a drain.

Refer to the following figures for grease fitting locations. See “Fluid Capaci-

ties/Lubricants” on page 31 for proper grease specifications. Wipe dirt from the

fittings before greasing them to prevent contamination. Replace any missing or

damaged fittings. Avoid excessive greasing to minimize dirt build-up.

Figure 102 – AL 500 Series – Grease Every 10 Hours (or daily)

A. All-Tach

System Pins (2)

B. All-Tach

System Pivots - Lower (2)

C. Lower Link Pivot - Front

D. Upper Link Pivot - Front

E. Lower Link Pivot - Rear

F. Loader Pivot

G. Tilt Cylinder - Front

H. LIft Cylinder - Front (2)

I. Upper Link Pivot - Rear

AL 500 Series (AL 400 Series Similar)

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 179 180

Sem comentários

Sharp R-440/540 Manual do Operador Página 138