Sharp ER-01PU Especificações descarregar pdf (Página 8)

ER-oIPu

Cautions

12. Near-end sensor

X When the power supply becomes ON after a long time (6 hours or

more) has passed, the system should be booted by means of

master reset of ER-01PU.

This is necessary because the memory maintaining time is ex-

ceeded. By transferring the initial data from the host computer to

ER-01PU by means of master reset, it becomes possible to per-

form operation even if memory maintaining is impossible.

X As charging is performed when the power supply becomes ON

after a long time, turning ON/OFF of the power of ER-01PU should

be avoided. (Note that there are cases where memory cannot be

maintained due to insufficient charging.)

1) General Description

The optional near-end sensors for journal and receipt are available.

ER-01PU has the connectors for journal and receipt near-end sen-

sors on the control substrate. Therefore, each optional near-end sen-

sor unit can be obtained and attached to ER-01PU.

2) Unit name

Near-end sensor: DUNT-5800BHZZ

3) Detecting method

Rolled paper diameter detecting type

CHAPTER 2. OPTIONS

1. Service options

No. NAME PARTS CODE

PRICE

RANK

DESCRIPTION

1 NEAR END SENSOR DUNT-58 00 BHZZ AZ

DRAWER CONNECTOR

QCNCM52 78 NCZZ

2. Supplies

No. NAME

PARTSCODE

PRICE

RANK

DESCRIPTION

1 ROLL PAPER TPAPR66 56RCfI !i

3. Special service tools

No.

NAME

PARTS CODE

MASTER ROM

VH i 2704 ORAY 1 A

SOFTWARE FOR SERVICE

UK~G-67 23 RCZIZ

1. Master ROM

2. Software for service

This is the EP-RPM used to write the ER-01PU software into the flash

The following software is provided in FD.

memory.

It is used when replacing the flash ROM in repair,

For the operating procedures, refer to “CHAPTER 11. IPL MODE.”

IOIPUDIAG.EXE]

fiis software is used to execute the diagnostics of the ER-01PU

through RS232 by the remote operation from PC.

For the operating procedures, refer to ‘CHAPTER 11. IPL

MODE.’

[lPL.EXEl

This software is used to write the ER-OIPU application program

IEROIPU,S] from PC into the flash memory of the ER-01PU.

For the operating procedures, refer to *CHAPTER 11. IPL

MODE.=

IEROIPU.S]

This is an application program which is written into the ER-OIPU

by the use of [lPL.EXEl.

For the operating procedures, refer to ‘CHAPTER 11. IPL

MODE.’

1-7

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 85 86

Comentários a estes Manuais

Sem comentários

Sharp ER-01PU Especificações Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir Sharp ER-01PU