Sharp ER-01PU Especificações descarregar pdf (Página 26)

ER-OIPU

[Function]

Selects the print density.

n = 00: 650/’of standard density (P)

n = 50: Standard density (P)

n = 99: 135 ‘/. of standard density (P)

[Default]

n = 50

No. COMMAND

FUNCTION

CODE

GS H n

Select printing position of

HRI character

c1Dh><48h> n

[Function]

Selects the HRI character printing position of HRI characters when

printing the bar code.

The printing position selected by “n” is shown below.

Printing position

O.48 Not Drinted

1, 49 Above the bar code

2, 50 Below the bar code

I 3.51 I Both above and below the barcode I

[Notes]

HRI characters are printed using the font specified by GS f.[Default]

[Default]

n=()

[Reference]

GS f:: Select font for HR1character

No. COMMAND FUNCTION

CODE

56 GS I n

Transmit printer ID <1Dh><49h> n

[Range]

[Function]

Transmits the printer ID shown below according to “n” when execut-

ing the command.

Type

Details

Data

1,49 Model

ER-OIPU

Olh

2,50 Set ID

See the table below

3, 51 ROM version ROM version

\ E%)IAh

bit

Description

o Ready for kanji character Yes/No 1/0

1 I Not defined

2 Not defined

3 Not defined

4 Fixed to O

5 Not defined

~ 6 I Fixed to O I

7 Fixed to O

[Notes]

When DTR/DSR control is selected, the status is transmitted after the

printer confirms that the host computer is ready to receive data (DSR

signal is ON). If the host computer is not ready to receive data (DSR

signal is OFF), the printer waits until the computer is ready.

When XON/XOFF control is selected, one byte is transmitted without

checking if is ready to receive data.

This command is executed during receive buffer expansion. There-

fore, if there is other data in the receive buffer, some delay may be

caused between command receiving and status transmitting,

The ROM version is changed each time the ROM is changed.

! No. I COMMAND I

FUNCTION

CODE

~-57 I GSPXY

I Set basic line feed Pitch [ <l Dh><50h>x Y 1

[Range]

05 X S 203,0 S Y S 203

[Function]

The basic calculation pitch in the horizontal direction is (l/X) inch; the

basic calculation pitch in the vertical direction is (l/Y) inch.

Returns to the initial value (X=203, Y=203) when x is Oand y is O.

[Notes]

Even if this command is executed, the other settings used currently

are not changed. That is, the other set data are changed only when

the corresponding setting is made after the basic line feed pitch is

changed.

The result of calculation combined with other commands for paper

feed amount setting, etc. is corrected with the minimum pitch (1/203)

and the remainder is discarded.

[Default]

X = Y = 203

[Reference]

ESC SP: Set character right-side spacing

ESC $:

Set absolute position

ESC 3:

Set line feed amount

ESC J: Print and feed paper

ESC \:

Set relative position

GS V: Cut paper

4-17

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 85 86

Comentários a estes Manuais

Sem comentários

Sharp ER-01PU Especificações Página 26

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir Sharp ER-01PU