Sharp SYSTEM 8/10 Plus Manual de Instruções descarregar pdf (Página 297)

100

101

Model 5014i to 5030i Upgrade Procedures

SHARP Connection Bracket Assembly Installation

Thermo Fisher Scientific Model 5030i SHARP Instruction Manual 10-3

STEPS

1 = UNFASTEN THUMB NUT

2 = SLIDE TAPE PICKUP SPOOL OFF

3 = SLIDE TAPE ASSEMBLY OUT TO GAIN ACCESS TO SCREW AREA (4)

4 = FASTEN 2X SCREWS TO CONNECTION BRACKET THRU WALL PLATE

5 = MAKE SURE CONNECTOR ORIENTATION CLOSER TO THIS EDGE

See Note 5

Figure 10–2. Tape Pick-up Spool Removal

3. Remove the two Philips screws from the connection bracket and align

the bracket onto the wall plate, as shown above in Step 4, and insert the

two screws through the wall plate and tighten.

4. Reinstall the tape pickup spool in the reverse order of removal in Step 2

by sliding all the spacers, O-rings and rear support guide plate into its

original assembly order.

5. Install the filter tape following the filter tape path shown in Figure 10–

3. Use adhesive tape to adhere the filter tape to the take up spool and

wind the tape over itself at least once.

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 402 403

Comentários a estes Manuais

Sem comentários

Sharp SYSTEM 8/10 Plus Manual de Instruções Página 297

Comentários a estes Manuais

Manuais e produtos relacionados com Comutadores de rede Sharp SYSTEM 8/10 Plus