Sharp AH-X10BE Manual do Utilizador descarregar pdf (Página 6)

118 1/4”

93 1/2”

Site Selection

1.2: Wherever possible you should use the surfaces described above. When this is not possible, we recommend you

use one of the following options:

Alternate Site Preparation

OPTION 1: Wood Platform

O1.1: Be sure you use lumber that is treated and approved for outdoor

use. Build outside frame to 93 1/2” x 118” outside dimensions:

Item Qty.

2” x 4” x 90 1/2” treated board* 8

2” x 4” x 118 1/4” treated board* 2

48” x 93 1/2”’ Plywood (ACX)** 2

22” x 93 1/2” Plywood (ACX)** 1

16d 3” common nails 32

8d 1 1/2” common nails 36

* All lumber must be rated for outdoor use

** Trim 4’ x 8’ sheets to this size

Note: Any platform or similar structure should be built above ground in order to avoid water pooling inside shed.

Surface must be leveled before installation. If the surface

is not properly leveled, the Outdoor shed will not assemble

or function correctly. Proper surface leveling will save you

time in the long run, so please do not ignore this step.

Remove the Parts List from the center of this manual, and locate color “Construction Tips”

insert in box.

Before Beginning!

10’

8’

118”

93 1/2”

1.1: The actual dimensions of your shed (at its widest and longest points) are 8’ x 10’. Be sure to select a

site that will accommodate these measurements. The base of the shed is slightly smaller than this, so you

will need to create a level surface that is at least 93 1/2” x 118”. We recommend using a level cement or

patio style surface. This will provide the best long-term performance for your shed.

Skylight Installation

15.1: Pre-fold Skylight (AJ)

before installing.

15.2: Push folded skylight up through opening; open skylight;

use tabs to pull skylight down into place.

15.3: Fasten skylight in place with screws (pull on tabs while inserting

screw to provide resistance).

LA (24)

LB (24)

Only use a hand screwdriver on this step

Hardware Bags:

HH11600

Repeat for all skylights.

Screwdriver

Align Doors

Fig. 1

Fig. 2

High Side

High side

Low side

Shim should be placed at the corner,

running directly under one wall.

First Shim

Second Shim

16.1: In some cases, the shed doors may not completely line up at the tops (ﬁ g. 1). When this happens, identify which

side is higher and use a shim (BD) to slightly raise the back corner of the high side until doors line up (ﬁ g. 2). If doors

need further adjustment, insert another shim under the front corner opposite of the ﬁ rst shim. If the doors still need

further adjustment, stack additional shims (one at a time) alternating between the back and front shims.

16.2: After doors are aligned, cut off any portion of wood shim that is still exposed. From inside the shed, drive a 1”

nail through the ﬂ oor into the shim to hold it in place.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comentários a estes Manuais

Sem comentários

Sharp AH-X10BE Manual do Utilizador Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Aparelhos de ar condicionado "split system" Sharp AH-X10BE