Sharp DP-750 Manual do Utilizador descarregar pdf (Página 12)

DP750 User's Manual

- 8 -

2.5.4 Connecting to the Serial Interface

1. Turn off both the computer and the printer. Plug the serial cable connector securely into the

printer's serial interface. Squeeze the wire clips together until they lock in place on both side of the

connector.

2. Plug the other end of the cable into the computer's serial interface; then tighten the screws on both

sides of the connector.

2.6 Connecting to the Power Cord

1. Make sure the printer is turned off.

2. Make sure the voltage required by the printer matches that of your electrical outlet.

3. If the power cord is not attached to the printer, connect it to the AC inlet on the printer.

4. Plug the power cord into a properly grounded electrical outlet.

To turn the printer ON, press the I mark at the side of the power switch.

To turn the printer OFF, press the O mark at the side of the power switch.

Caution: 1.If the rated voltage and your outlet voltage do not match, contact your dealer for

Figure 2-13 Connecting to the serial interface

Serial cable

Serial interface

Screw

Figure 2-13 Connecting the power cord to the printer

↑

↓

OFF

Figure 2-14 Turning the Power on and off

Power switch

Power supply inlet

Electrical outlet

Power cord

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 52 53

Sem comentários

Sharp DP-750 Manual do Utilizador Página 12