Sharp JW-50FL Manual do Utilizador descarregar pdf (Página 67)

1 - 60

1 2 Port Adapter (ZM-1MD2)

CPU

MITSUBISHI A Series PC

Q Series

POWER

RUN

SYSTEM

F 2

F 3

F 1

F 4

F 5

F 6

F 7

ZM Series

This ZM

becomes a

bit faster

POWER

RUN

SYSTEM

F 2

F 3

F 1

F 4

F 5

F 6

F 7

-M

ZM Series

Connecting cable

(Mitsubishi made : optional)

Connect the

connector which is

found on the back

side directly to the

CPU port.

123

Slide switch

Use when select the conne-

ction model.

1: A series (ACPU port)

2: CnA series (QnA CPU port)

3: FX series

(Note) Change the slide switch

before power supply.

When connecting 2 units together

Caution

1 Since the power supply of ZM-1MD2 is supplied from CPU, pay attention to capacity of 5V power supply

of CPU.

2 For wiring, it is fully careful to a noise.

3 There is the following restriction when ZM-1MD2 is used for QnA series CPU port.

1. When using it in ZM40/61 series, re-try time is 3 seconds.

The communication time out is 20 seconds between GPP and CPU.When any communication error

occurs between GPP and CPU, ZM-1MD2 maintains 20 seconds as communication time between

GPP and CPU.

After passing 20 seconds, although a communication port is changed to ZM between CPUs, since it is

3 seconds, the re-try time of ZM-40/60 series serves as a time-out, and a communication error occurs.

Perform re-execution 20 seconds after.

2. When you use it in ZM-41/70/80 series, choose from the two following methods.

- With the [Detail Setting] menu of the [Communication Parameter] of a [System Setup], [Communication

error processing] is set as "Continuation."

- [Time-out time]x [re-try time] may become more than 20 seconds.

3. Write in running

When the write-in operation in running is performed from GPP side and the time required is larger than

20 seconds, ZM-1MD2 cannot be used. In this case, written in STOP state for PC.

In addition, although the number of steps of the program which can perform writing among RUN in

less than 20 seconds has a difference according to the contents of a program, it is computable in the

following formula as a standard.

Time = (Number of steps ÷ 60) × scan time (msec)

A standard is asked in this formula. In addition, in the case of constant scan, this formula cannot apply.

4. When a power supply is switched on where a console is connected to the ZM-1MD2, a console will

become a communication time-out before completing initialization of the ZM-1MD2.

When it connects again or reset operation of a console is performed once it, removes the cable of a

console, it will return to a normal state. (Normal operation of this machine is carried out after 15 seconds

progress from the time of a power supply injection.)

4 When you use ZM-1MD2 for A series/FX series CPU, set time-out time as 1.5 seconds or more by commu

-nication parameter setup of ZM41/70/80.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 200 201

Comentários a estes Manuais

Sem comentários

Sharp JW-50FL Manual do Utilizador Página 67

Comentários a estes Manuais

Manuais e produtos relacionados com Impressora multifunções Sharp JW-50FL