Sharp R-652M Instruções de Operação descarregar pdf (Página 39)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 35

2015-01-26 Table of Contents Index 401-652M

Field Set-Up Checklists

Use the following tables to develop a ﬁnal checklist for

your tractor/planter conﬁguration.

Additional or fewer steps may be necessary depending

on tractor features, planter options and planting

accessories.

Mechanical Checklist (Hitching) Page

Planter hitched 13

Parking stands raised 17

Electrical Checklist Page

Verify electrical hookups solid 13

Check seed monitor terminal and observe

any diagnostic messages

a. Refer to monitor manual.

Option: Verify that, when planter is

lowered, optional radar speed sensor is

pointed at ground, at an angle

approximately 35° below horizontal.

b. Refer to sensor documentation.

Hydraulic System Checklist Page

Check tractor hydraulic reservoir full -

Fan case drain

Fan return

Fan motor pressure side (retract)

Inspect connections for leaks -

Check fan speed and airﬂow direction

a. Operate fan brieﬂy. Observe rotor blades spinning

toward exit port as fan slows to a stop.

Mechanical Checklist (post-Hitching) Page

Planter leveled 18

Marker extension set 115

Marker disc angle set 42

Markers folded (unless already at start of

ﬁrst planting row)

Planter Meter Drive Checklist Page

Check chain lubrication and slack 83

Calibrate speed sensor pulses with planter

lowered.

a. Refer to seed monitor manual.

Seeding: Set/check Range and

Transmission against rate chart

b. Refer to Seed and Fertilizer Rate manual.

Air System Checklist Page

Fan butterﬂy valve set 31

Seed loaded. Lids closed. 24

Meter shutters open to chart value 55

No air leaks (except from seed hoppers)

Hoses and tubing - no sags, no pinches

Check both manifold and sensor lines

Hoses fully connected to meters

Row Units Checklist Page

Preset depth handles alike. 52

Preset down force springs alike, except in

tracks.

Option: Set all unit-mounted coulters to

⁄

inch shallower than opener blades.

Check coulter alignment to row 51

Check closing wheel alignment 62

Set press wheels alike, except in tracks. 62

Check action and contact of side depth

wheels

Check wheel scraper gaps (if installed) 54

Slide gates open 24

Meters Checklist Page

Corn?

Check timing of meters for twin-row

a. Refer to Seed and Fertilizer Rate manual.

Check chain tension. Re-connect any

loose idler tensioning springs.

Correct disks for seed

Start fan. Operate at ﬁeld manifold

pressure.

Rotate meter drive shafts one turn disks

with seed.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 127 128

Comentários a estes Manuais

Sem comentários

Sharp R-652M Instruções de Operação Página 39

Comentários a estes Manuais

Manuais e produtos relacionados com Micro-ondas Sharp R-652M