Sharp SL-550 Guia de Resolução de Problemas descarregar pdf (Página 29)

• A-29 • Set-up/Operation

Taking Down and Packing Up

The STARLAB

After you have completed your STARLAB presentations for the day, it’s time to break

down and repack the STARLAB back into its cases.

Note

If you are going to use the STARLAB for several days and it’s in a secure

room, it is not necessary to completely pack it up each night. Simply place

the projector on the ﬂoor next to the stand, leave the side lights on and exit

the dome. Pull out the power cords and turn off the fan. The STARLAB will

deﬂate and the fabric will rest on the stand making a “tent” over the projec-

tor. When you turn the fan on again, the STARLAB dome will inﬂate and

then you can plug in the projector and place it back on the stand, picking

up where you left off the day before.

Start by removing all planet projectors and moon phases from the Stareld cylinder

and putting them back into their proper places in the accessory box. Make sure that

you replace the steel light blocks in all the light ports, take the Stareld cylinder off

the projector and slide it back in one of the round storage compartments in the pro-

jector case. Turn off the projector and place it on the oor next to the projector stand.

Exit the dome and turn off the fan. The STARLAB dome will begin to deate. After it

has dropped about 3 feet, go to the side of the dome opposite the two tunnels and lift

the material about 5 feet off the ground ipping it back toward the opposite side of

the dome. If you do this quickly, the dome will ride back on the air that was trapped

inside forming a crescent shaped pile of fabric on the oor as shown in drawing at

right. Allow the dome to sit for a few minutes so that the remaining air gets out of it

and continue packing up the projector and fan.

Unplug the fan from the power outlet and unsnap the ination tube. Wrap the power

cord of the fan around the two metal brackets on the back of the fan and place the

fan inside its box, snapping the lid shut. Place the fan case off to the side so that it is

out of the way.

Unplug the projector from its power outlet and unplug the power to the motor that

controls the daily motion from the back of the projector. Make sure that the latitude

adjustment for the projector is set at 90 degrees (polar position, straight up and

down) and carefully wrap the power cord for the projector around the base of the

projector directly underneath the clear plastic cylinder platform. Put the protective

packing material back on the top of the projector. Lay the projector case/stand so

that it is at on its back on the oor and place the projector inside the large rectangu-

lar compartment.

Note

Always carry the projector by the two heavy metal bars on either side. Place

the accessory box in the smaller rectangular compartment of the projector

case along with any ﬂashlights, extra pointers or other accessories that you

are using with your STARLAB. Make certain that the pointers are turned off

before storing them in the accessory box!

Place the lid on the projector case by inserting the two hinges in their tabs.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Comentários a estes Manuais

Sem comentários

Sharp SL-550 Guia de Resolução de Problemas Página 29

Comentários a estes Manuais

Manuais e produtos relacionados com Projetores de dados Sharp SL-550