Sharp SL-550 Guia de Resolução de Problemas descarregar pdf (Página 12)

Set-up/Operation • A-12 •

jector case and store it in a safe location outside of the dome.* Then lay the case at

on its back, lift the side of the inated dome and slide the box under the fabric.

Unravel the power cord that is attached to the projector and plug it in.

Note

Do not plug in the projector until after the protective coverings have been

removed. If the projector was left in the “on” position, the plastic bulb cover-

ing can melt into the projector head causing damage!

Refer to the two diagrams of the projector and follow these simple steps.

1. Plug in the motor drive for the daily motion on the projector as indicated in the

diagram. On the back of the projector is a large 3 prong plug attached to a

short wire that must be plugged into the large 3 prong outlet in the back of the

projector.

2. Check to make sure that the projection lamp plug is plugged in.

3. Turn on the projector by turning the left-hand knob in a clockwise direction. You

should see the LED on the projector light.

4. Turn the right hand knob all the way in a clockwise direction to turn on the side

lamps. These will provide ample work light for you to set up the projector inside

the dome.

5. With the projector on, lift the side of the dome and carefully slide the projector

into the dome making sure that the lights don’t rest against the fabric. You can

now enter the dome and continue setting up the projector.

Once the projector and carrying case (stand) are inside the dome, you can set the

projector on its stand and prepare to conduct the program. Turn the case on its side

so that the handle is pointing toward the ination tunnel. The handle should not be on

the top of the box. Move the case to the center of the dome and carefully place the

projector on the box so that the side lamps shine down over the side of the box. (See

top photo next page.) The main projector bulb should be directly under the center of

the dome.

* A new style of travel

cases began shipping with

systems in January 2005.

If you have new cases,

please refer to the note on

the top of page 13.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sem comentários

Sharp SL-550 Guia de Resolução de Problemas Página 12