Sharp Intellisync Manual do Utilizador descarregar pdf (Página 35)

SL-C1000/3x00 Quickstart ///TRIsoft OHG

SHARP SL-C1000/3x00 Page 35

Boot to command-line

In addition to the Diag / Service menu (see page 31) there is a boot option for the

“classic” Login-Prompt. This may be useful for emergency recovery.

The procedure is similar to the Diag / Service mode instead you have to press the keys

“DB”. So, here we go:

• Flip the battery switch to “Offen” and pull the battery out

• wait appr. 1 minute

• Press and hold “D” + “B” keys.

• Re-insert the battery

• Flip the switch back to “Betrieb”

• Tick the “Reset” button

• Continue holding “D” + “B” pressed and power the Zaurus on

Now you should see the white bootscreen with the red SHARP-Logo. But this time the

screen should scroll up, revealing the following lines:

INIT: version 2.78 booting

INIT: Entering runlevel: 4

INIT: Sending processes the TERM signal

Lineo uLinux

Kernel 2.4.20 on armv5tel

zaurus login :

You may now login as “zaurus” or “root”. In this mode the Zaurus won’t react on the

power switch, so you’re unable to turn the device off. End the session with “reboot” to

boot back to the QTopia desktop.

Note:

We encountered Zauris which needed up to 1 hour without a battery to accept the

“DB”-trick. If your Zaurus won’t react as described below, don’t worry and try it again with

a longer “batteryless” time.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41

Sem comentários

Sharp Intellisync Manual do Utilizador Página 35