Sharp CD-E250E Guia de Instalação

Consulte online ou descarregue Guia de Instalação para não Sharp CD-E250E. Sharp CD-E250E Installation guide Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 0
For maximum effectiveness and safety,
please read these instructions completely
before proceeding with installation.
Failure to read these instructions can result in an
incorrect installation.
MN-748 • (021210) • ECR 7428
INSTALLATION GUIDE
Kit 57138
Ford E-250/E-350 Van &
E-350 Commercial Chassis
rear application
LoadLIFTER
5000
Vista de página 0
1 2 3 4 5 6 ... 19 20

Resumo do Conteúdo

Página 1 - LoadLIFTER

For maximum effectiveness and safety, please read these instructions completely before proceeding with installation.Failure to read these instructions

Página 2

MN-7488ATTACHING THE LOWER BRACKETMost late model vehicles have a small brake line hanger on the passenger side shock bracket that is welded to t

Página 3 - TABLE OF CONTENTS

MN-7489Some late models are equipped with the RSC (roll stability control) system (g. 16). On these models it will be necessary to loosen the axle ve

Página 4 - Introduction

MN-74810CAUTIONWHEN CUTTING OR TRIMMING THE AIR LINE, USE A HOSE CUTTER, A RAZOR BLADE, OR A SHARP KNIFE. A CLEAN, SQUARE CUT WILL ENSURE AGAINST LEAK

Página 5 - Kit Hardware and Tools

MN-748117. Cut off the air line, leaving approximately 12” of extra air line. A clean square cut will ensure against leaks. Insert the air line into

Página 6 - GETTING STARTED

MN-74812 Overnight leak down test — Recheck air pressure after the vehicle has been used for 24 hours. If the pressure has dropped more than 5 PSI,

Página 7

MN-74813Product Use, Maintenance and Servicing5 PSI100 PSIFAILURE TO MAINTAIN CORRECT MINIMUM PRESSURE (OR PRESSURE PROPORTIONAL TO LOAD), BOTTOMING O

Página 8 - ATTACHING THE UPPER BRACKET

MN-74814Frequently Asked QuestionsQ. Will installing air springs increase the weight ratings of a vehicle?No. Adding air springs will not change the w

Página 9

MN-74815g. 23 g. 24Bad headlight aimRough rideSway and body rollg. 251. Start with the vehicle level or slightly above.2. When in doubt, always a

Página 10 - LoadLifter 5000

MN-74816Air Lift 1000 ... Lifetime LimitedRideControl ... Lifetime LimitedLoadLifter 5000*... Lifetime Lim

Página 11

MN-74817Replacement InformationIf you need replacement parts, contact the local dealer or call Air Lift customer service at(800) 248-0892. Most parts

Página 13 - FIXING LEAKS

Air Lift Company • 2727 Snow Road • Lansing, MI 48917 or PO Box 80167 • Lansing, MI 48908-0167 Toll Free (800) 248-0892 • Local (517) 322-2144 • Fax (

Página 14 - Before Operating

Introduction ... 2Important Safety Notice ...2Notation Explanation ...

Página 15 - MAINTENANCE GUIDELINES

MN-7482IntroductionThe purpose of this publication is to assist with the installation, maintenance and troubleshooting of the LoadLifter 5000 air spri

Página 16 - Troubleshooting Guide

MN-7483Kit Hardware and ToolsTOOLS LISTDescription ... QtyJack ...

Página 17 - Guidelines for Adding Air

MN-7484YOUR VEHICLE MAY BE EQUIPPED WITH A REAR BRAKE PROPORTIONING VALVE. ANY TYPE OF LOAD ASSIST PRODUCT COULD AFFECT BRAKE PERFORMANCE. WE RECOMME

Página 18 - Warranty and Returns Policy

MN-7485Finger tight only. Do not over tighten.4. LOOSELY install the 3/8” lock washer (N) and 3/8 x 7/8” hex head cap screws (M). Leave loose to al

Página 19 - Contact Information

MN-7486LOWERING THE SUSPENSIONIt will be necessary to lower the suspension of the vehicle in order to provide clearance to install the air spring unit

Página 20 - Need Help?

MN-74873. Secure the stud using at washer (K) and 3/8” lock nut (J). See g. 9. Torque stud nut to 16ft-lbs.4. Tighten the hex head bolt securely

Comentários a estes Manuais

Sem comentários