Sharp MZ-1F11 Manual de Instruções

INTRODUCTION Thank you for buying the MZ-1 E14 SHARP MZ Disk Interface. The MZ disk interface is used together with the MZ-1 F11 MZ disk drive, used

PINOUT OF CONNECTORS To computer ~ -:.;"'t; <::.<::. {" of" ~<b co ~ !'o ... <::. ~"'t' (J ...

Model Operating power Operating temperature Operating humidity ROM IC Dimensions Weight Accessories SPECIFICATIONS MZ-l E14 +5 VDC ± 5% 1Q°C - 35°C 20

* * * * NOTES * * * *

SHARP CORPORATION OSAKA, JAPAN Printed in Japan Gedruckt in Japan Imprime au Japan Stampato in Giappone © 1984 SHARP CORPORATION 4G 2.10 (TINSE1215

Caution 1. Do not use this unit where rapid increases or decreases in temperature occur or in a humid or dusty environment. This unit consists of

CONTENTS Overview ... . Parts of the Interface. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

OVERVIEW This interface connects an MZ-700 series personal computer and the MZ-1 F11 disk drive. The interface reads the system software (BAS

PARTS OF THE INTERFACE Connector for 26-pin cable from the MZ-1 F11 disk drive Connector guide pin (Between 6th and 7th pin) Connector to MZ-700 seri

CONNECTION To connect the MZ disk drive to an MZ-700 series computer, perform the following. 1. Remove the data recorder, or the cover (for MZ-7

2. Jnstall the MZ·1 F11 1) Remove the bottom plate of the MZ·1 F11 as follows: (1) Unscrew the screws holding the bottom plate at the rear side. (2)

2) Connect CN2 (from the bottom of MZ-1 F11) to the conneC1Dt ·of the computer main unit that was originally connected to the data recorder. (F

; Connector cover Figure 4 3. Connecting the MZ-1E14 and the MZ-1F11 (Figure 4) 1) Remove the cover for the external output terminal (I/O BUS) at