Sharp 32L-X2000 Manual de Instruções descarregar pdf (Página 8)

3) WIRE ROPE DRIVING SYSTEM XE301P

3-1 Introduction

Although the drive system of the Tirak hoist is

one of the most simple and reliable system in the

market, it still requires service from an authorized

repair station for safe and efficient operation. It is

recommended the following service procedures

are performed every six (6) months but they may

need to be repeated more often depending on the

work environment the hoist is subjected to.

3-2 Tools Required (Figure 301)

- Hammer

- Screwdriver (2, flat)

- 10mm Box wrench

- Rubber mallet

- Diagonal cutting pliers

- 5 mm Allen key

- Pry Bars

3-3 Blocstop Removal

Using diagonal cutting pliers, detach the Blocstop

BSO500 strap from the hoist by removing the

cotter pin shown in Figure 302.

3-4 External Inspection

1) Inspect outer casing {Code #63695, Pos. 2}

for damage. Pay extra attention to the area

indicated shown in Figure 303. Look for

deformation or marks that may indicate

further damage inside.

2) Inspect the stirrup adapter and the

surrounding area as shown in Figure 304 for

wear, cracks or damage. If the stirrup bar

{Code #47867, Pos. 86} is bent, it indicates

improper rigging. Replace if necessary.

NOTE

Regular Inspection services will decrease

downtime.

Figure 301

Figure 302

Figure 303

Figure 304

NOTE

Parts and codes referred to in this section are

found on the spare parts list at the end of the

chapter (E-27610, Section 3-13).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 76 77

Comentários a estes Manuais

Sem comentários

Sharp 32L-X2000 Manual de Instruções Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com TVs e monitores Sharp 32L-X2000