Sharp XG-C40XUSL Manual do Utilizador descarregar pdf (Página 6)

XG-C40XU

(

)

XG-C40XE

(

)

No. Adjusting point Adjusting conditions Adjusting procedure

13 Horizontal

center

1. Feed the NTSC monoscope

pattern signal.

2. Group : VIDEO 2

Subject : N358-DLY (4)

N443-DLY (0)

PAL-DLY (3)

SECAM-DLY (0)

Make sure the settings are

as above.

3. Group : VIDEO 1

Subject : NTSC-H

» Using the control switches or the remote controller

buttons, adjust the data to have the same overscan

in Reft and Right.

2.0Vp-p

14 Video picture

adjustment

1. Feed the split colour bar sig-

nal.

Group : VIDEO 1

Subject : PICTURE

2. Connect the oscilloscope

between pin (2) of P801 and

GND.

» Using the control switches or the remote controller

buttons, adjust the black-to-white (100%) level

difference to 2.0 ±0.06 Vp-p.

17 Tint 1. Feed the split colour bar

signal.

Group : VIDEO 1

Subject : TINT

2. Connect the oscilloscope to

pin (4) of P801.

» Using the control switches or the remote controller

buttons, adjust the data to have the -(B-Y) wave-

form downhill straight.

» After adjusting, adjust the

value of TINT up 3 point.

16 Video AGC 1.

Feed the split colour bar signal.

Group : VIDEO 1

Subject : AGC

» Using the control switches or the remote controller

buttons, adjust the setting until the white signal

becomes bit-less.

15 Video

brightness

adjustment

1. Feed the baseband (split

colour bar) signal. (The ON-

AIR signal is not accepted

because of its too much

noise.)

Group : VIDEO 2

Subject :

VROS/VGOS/VBOS

2. Press the control switch or

the remote control’s mute

button (to set the gamma

correction to the process

setting).

» Using the control switches or the remote controller

buttons, adjust the setting until the black signal

becomes bit-less.

100% White Red

18 NTSC colour

saturation level

1. Feed the split colour bar sig-

nal.

Group : VIDEO 1

Subject : N-COLOR

2. Connect the oscilloscope to

pin (1) of P801.

» Using the control switches or the remote controller

buttons, adjust the difference between the 100%

white portion and the red portion to 0.00 ±0.05 Vp-p.

(same as 100% white)

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Comentários a estes Manuais

Sem comentários

Sharp XG-C40XUSL Manual do Utilizador Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Projetores Sharp XG-C40XUSL