Sharp AL-1551 Manual do Utilizador descarregar pdf (Página 17)

Installation

LOADING COPY PAPER

Gently push the paper tray back into the copier.

After loading copy paper, to cancel the blinking “P” without restarting copying,

press the clear ( ) key. The “P” in the display will go out and the ready ( )

indicator will light up.

POWER TO COPIER

Ensure that the power switch of the copier is in the OFF position. Insert the attached

power cord into the power cord socket at the rear of the copier.

If you use the copier in a country other than the country where the copier was

purchased, you will need to make sure that your local power supply is compatible

with your model. If you plug the copier into an incompatible power supply,

irreparable damage to the copier will result.

Plug the other end of the power cord into the nearest outlet.

Only insert the power cord into a properly grounded wall socket.

Do not use extension cords or power strips.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

Sem comentários

Sharp AL-1551 Manual do Utilizador Página 17