Sharp R-370E Manual do Operador descarregar pdf (Página 27)

8.0 Operation

The SEND key is used to send the backgauge to any valid position. If an attempt is made to send the

backgauge to an illegal position, an error message will be displayed at the bottom of the screen

stating “Number outside limit”. In the Job mode, the SEND key will also advance the backgauge to

the next sequential cut position before performing the cut.

8.8.5 Push-Out Key

The push-out key will move the backgauge forward 5 inches (or to the most forward position) and

then return it to its previous position. This allows paper to be removed from the cutter without putting

hands under the knife and clamp. It also allows the backgauge to run forward under program control

if the light beams are blocked for dimensions less than 4.7 inches.

Never place hands in the clamp and knife area. Use the push-out key

or the backgauge glide control to move the paper to an area where it can be reached.

8.8.6 Clear Key

The CLEAR key is used to clear error messages and the current entry line.

8.8.7 Enter Key

The ENTER key selects items in the maintenance mode and processes data that has been entered in

the other modes.

8.8.8 Priority Add (X/Y) Key

The Priority Add key is used for entering fractions when they are combined with whole numbers. The

symbol displayed when this key is pressed is the underline symbol “_”. An example of a number

entered using the Priority Add key is 1_1/2.

8.8.9 Soft-Keys

There are a total of eight soft-keys labeled “A” through “H”. The functions of these keys change

depending on the operating mode. The function of each key can be found on the bottom of the

display screens.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 58 59

Sem comentários

Sharp R-370E Manual do Operador Página 27