Sharp R-370E Manual do Operador descarregar pdf (Página 19)

6.0 Installation & Setup

can be removed for changing the oil and checking the oil level. The reservoir should be kept full at all

times. Fill the reservoir so that the oil level is 3/4” below the top of the inside of the hydraulic tank.

NOTE: DO NOT OVERFILL. Overfilling may cause leakage when the machine is hot.

Figure 10

6.9 Power Hook-Up

SHOCK HAZARD! Always disconnect power at main power panel

before working on the cutter. Lock it out to prevent accidental power up. See Power Lockout

Procedure (page 5).

For satisfactory operation, be sure that your cutter is wired for the correct phase and voltage and has

adequate power. The correct electrical specifications for your machine are shown on the serial plate.

Check the machine serial plate before connecting the power. For future reference, transfer this

information to the front cover of this manual.

Watch Setup Voltage- Inadequate power to the cutter can be a major source of problems. Too

many machines on the same circuit will reduce the power to each machine. Inadequate voltage will

frequently cause overheating, loss of power, and in extreme cases, failure to operate. Test your

voltage when the shop is at actual working levels. Challenge recommends a dedicated line with a

lockable disconnect to provide adequate power for this machine.

Important: You must have an adequate size circuit and heavy enough wiring for this machine. The

circuit size should be a minimum of 20% greater than the amperage rating on the machine

nameplate. If a wire is run over 75 feet (23 meters), the next size wire should be used. Check local

electrical codes.

Electrical Specifications for Champion 370 cutters:

Volts Amps Circuit Size Wire Size Metric Wire

3 Phase:460 V 11.5 16.5 A #12 AWG 4mm sq.

230 25 38 #8 10mm sq.

208 25 38 #8 10mm sq.

Breather

Cap

Hydraulic

Reservoir

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 58 59

Sem comentários

Sharp R-370E Manual do Operador Página 19