Sharp 21F-A30 Manual do Operador descarregar pdf (Página 167)

MAINTENANCE AND SERVICING

Form 169000 / 169040 165 Revision C

g. Slide upper roll driveline onto gearbox as shown.

Install and tighten two bolts and nuts (O).

Torque to 75 ft·lbf (102 N·m).

h. Attach lower roll driveline flange onto gearbox

flange using four bolts and nuts (P).

i. Adjust roll timing. Refer to Section 6.17.11.2

Roll Timing and Alignment.

j. Clean off excess sealant from motor flange and

gearbox face.

k. Apply light coat of silicone to motor flange, and

position motor on gearbox as shown until

mounting holes are aligned, and pinion engages

gear in gearbox.

l. Install bolts (Q) and washers, and torque to

75 ft·lbf (102 N·m).

m. Re-connect hoses to motor.

n. Close all shields before engaging header.

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 191 192

Sem comentários

Sharp 21F-A30 Manual do Operador Página 167