Sharp e-Copy ShareScan Guia de Configuração descarregar pdf (Página 116)

104 | Quick Start: Setting up MFP devices to work with Send to eCopy

Configuring a Sharp MFP

To configure a Sharp MFP to use with Send to eCopy, you create a profile that uses a shared

network folder (see page 104) that uses the Microsoft SMB (Server Message Block) Protocol, or a

profile that uses an FTP folder (see page 105).

You can then scan documents to the scan destination (see page 107).

Creating a profile that uses a shared network folder

If you are using a shared network folder (SMB) to store scanned image documents on the

ScanStation, you specify the path to the target folder in a profile. You can use an existing profile

or you can create a new profile. The user at the MFP selects the scan destination specified in the

profile.

You should use the Sharp Network Scanner Tool — not the Web Setup button — to create any

profiles that you plan to use with Send to eCopy.

The instructions in this section assume that you have installed Sharpdesk and accepted the default

profiles. The procedure describes only the steps that you need to complete to enable use of the

MFP with Send to eCopy.

To create a profile that uses a shared network folder:

1 To run the Network Scanner Tool, select Start > Programs > Sharpdesk > Network

Scanner Tool.

The Profiles tab lists all available profiles. You can use an existing profile with Send to

eCopy.

2 On the Profiles tab, click New.

The Properties for Profile window opens.

3 Specify the profile name, which will appear on the MFP’s control panel, and descriptive

information, such as, “Scan to shared folder for eCopy”.

4 Select the Move File to Folder check box and then click Details.

The Send To Folder window opens.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 354 355

Sem comentários

Sharp e-Copy ShareScan Guia de Configuração Página 116