Sharp CD-M4000 Guia do Utilizador descarregar pdf (Página 401)

100

101

testsb(8)

System Administration 379

NAME testsb - perform an initial diagnosis of the specified physical system board (PSB)

SYNOPSIS testsb [[-q] -{y|n}][-m diag=mode] location

testsb -v [ -y|-n][-m diag=mode] location

testsb -h

DESCRIPTION testsb(8) command performs an initial diagnosis of the specified PSB.

The configuration of the PSB and operation of each device mounted on the PSB are

checked. After the diagnostics, the result is displayed. The PSB must not be

configured in the domain, or the domain in which the PSB configured must be

powered off.

The result also can be seen in ‘Test’ and ‘Fault’ displayed by showboards(8)

command.

Privileges You must have platadm or fieldeng privileges to run this command.

Refer to setprivileges(8) for more information.

OPTIONS The following options are supported:.

OPERANDS The following operand is supported:

EXTENDED

DESCRIPTION

■ When the system board (XSB: eXtended System Board) belonging to the specified

PSB is in any status below, the testsb(8) command results in an error.

■ XSB is installed in the domain and this domain is in operation.

-h Displays usage statement. When used with other options or

operands, an error occurs.

-m diag=mode Specifies the diagnostic level of initial diagnosis. One of the

values shown below can be specified:

min Normal (default)

max Maximum

-n Automatically answers 'n' (no) to all prompts.

-q Suppresses all messages to stdout, including prompts.

-v Displays a detailed message of initial diagnosis.

-y Automatically answers 'y' (yes) to all prompts.

location Specifies only one PSB number. An integer from 00–15 can be

specified.

1 2 ... 396 397 398 399 400 401 402 403 404 405 406 ... 419 420

Comentários a estes Manuais

Sem comentários

Sharp CD-M4000 Guia do Utilizador Página 401

Comentários a estes Manuais

Manuais e produtos relacionados com Software Sharp CD-M4000