Sharp R-8730-A Especificações descarregar pdf (Página 8)

OPERATION

NORMAL OPERATION

Fill the hopper with coffee beans.

Place the appropriate filter paper in your brewer’s brew chamber. Slide

the brew chamber under the grind head on the guide rails.

Press the start button. When the grinder stops, remove the brew

chamber and proceed with your normal brew sequence.

GRINDER PROTECTION DEVICES

The grinder is equipped with a circuit breaker and a shear dish to

protect the motor and grinder burrs in the event of a jam or solid object

entering the grind head.

If the grinder does not operate when the start button is pressed, the

circuit breaker may be tripped. The circuit breaker is located on the

back of the grinder, near the power cord inlet. When tripped, the

center pin of the breaker will “pop” out approximately 1/4”. Press the

pin straight in until it “clicks” to reset.

If the grinder motor runs but the grinder does not grind coffee, the

shear disk may have released. Refer to maintenance procedures for

shear disk replacement.

CAUTION:

CUT / PINCH

HAZARD

DO NOT reach into the

hopper or discharge chute

without first unplugging the

unit from electric power.

Fig. 3 Grinder Operation

IMPORTANT:

Before resetting the circuit

breaker or replacing the

shear disk, endeavor to

locate and clear the source

of the jam. Unplug the

grinder from electric power

before reaching into the

hopper or discharge chute.

Fig 4. Reset Circuit

Breaker

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sem comentários

Sharp R-8730-A Especificações Página 8