Sharp R-230L Instruções de Operação descarregar pdf (Página 24)

10.1 Checks before sawing

– The rail supports and guide pulley stands must be correctly fastened (all screws tightened securely.

– The saw head must be mounted without play, the saw arm in the vertical position (at 90° to the rail), the cam-

action rollers engaged (DS-TS 30 1

gear).

– The wire tensioning pulley and drive wheel guard must be fitted and secured in position with the clamping

screw at the side of the blade guard holder.

– The drive wheel must be fitted and secured with the standard saw blade flange and central mounting screw.

– The drive wheel guard cover must be fitted.

– The wire distributor assembly must be fitted at the front end of the rail using the standard rail taper and eccen-

tric pin.

– The end stop must be fitted at the rear end of the rail.

– The wire length adjusting pulley and rolled-up diamond wire guard must be fitted and the rubber diamond wire

guard attached to the drive wheel guard.

– The hydraulic hoses and water hoses must be connected correctly. (The two control hoses for the saw arm

plunge movement do not have to be connected as only the longitudinal advance movement is required for wire

sawing.)

– Electric power and water must be available. The EMERGENCY STOP buttons on the hydraulic power unit and

remote control unit must be disengaged (pulled out) and all controls on the electric remote control unit set to

the OFF / 0 or neutral position.

– The working area must be cordoned off. All safety distances must be observed.

– The diamond wire must be connected correctly, aligned properly and it must be possible to pull the wire through

easily by hand.

32-50 A

D-RC-LP 32

Start

Ampere

32 63

1200

10. DS-WSS 30 wire saw system - checks, operation and the sawing procedure

Printed: 08.07.2013 | Doc-Nr: PUB / 5069762 / 000 / 01

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Sem comentários

Sharp R-230L Instruções de Operação Página 24