Sharp AR-C360P Guia de Instalação descarregar pdf (Página 3)

3

Network Installation

Windows (cont’d)

2 Connect the Ethernet Interface

1. Switch off the printer and computer.

2. Remove the protective cover from the network

connector on the printer.

3. Connect the Ethernet cable between the print

and the Ethernet hub.

3 Assign an IP address to the printer

If you are not using DHCP, you need to obtain an IP

Address from your network Administrator and

enter it using the front panel:

1. Confirm that the printer displays [Ready to

print

].

2. Press

∇ key until [Admin Setup] appears. Press

the Enter key.

3.

Continue to Setup? displays. Press ENTER to

select

Yes. The printer goes offline and Running

Setup

displays. This will take about a minute.

4. The Setup Menu displays, press

∇ to select

Network Setup. Press ENTER.

5. Press

∇ to select Protocol Setup. Press ENTER.

6. Press

∇ to select TCP/IP Setup. Press ENTER.

7. Press

∇ to select Ethernet Setup. Press ENTER.

8.

TCP/IP Ethernet displays. Select YES and press

ENTER.

Enable AutoIP Config? displays. Select NO.

Press ENTER.

9. The default IP Address displays. Use

∆ or ∇ to

change each octet. Press ENTER to proceed to

the next octet or to leave the octet unchanged.

10.

Subnet Mask displays. Repeat instructions in step

9.

11.

TCP/IP bound to Ethernet displays. Press ENTER.

12.

Gateway Address displays. Repeat instructions in

step 9.

13.Press ENTER to exit TCP/IP Setup, Protocol

Setup, and Network Setup.

14.Select

Yes and press ENTER to Save Changes.

Press ENTER to Exit the Setup Menu.

15.Printer restarts the server and initializes.

Ready

to Print

displays.

NOTE

For more information, see the Configuration Guide

on the User Documentation CD.

1 2 3 4 5 6 7 8 ... 28 29

Comentários a estes Manuais

Sem comentários