Sharp IQ-8000 Manual de Instalação descarregar pdf (Página 20)

3.0 Installing Power

3.1 Installing Power

Shown below are the 3.0A and 6.0A PCSC power supplies. Both power supplies are shown in

enclosures connected to an IQ-400 manual in a PCSC small enclosure.

3.1.1 Installing Power- 3.0 Amp

See Figure 1 in Section 3.1.3.

12VDC power is connected to the circuit board at P1 in the upper left corner. Disconnect

power mains from the supply until the wiring is secured.

For installation, refer to the ESD SPS-3.6M2E or SPS-6.5M4 Power Supply installation

instructions (P/N: SPS36instructions Rev: 04/15/02).

3.1.2 Installing Power- 6.0 Amp

See Figure 2 in Section 3.1.4.

12VDC power is connected to the circuit board at P1 in the upper left corner. Disconnect

power mains from the supply until the wiring is secured.

For installation, refer to the ESD SPS-3.6M2E or SPS-6.5M4 Power Supply installation

instructions (P/N: SPS36instructions Rev: 04/15/02).

NOTE: Power supply cable connections are non power-limited outputs. For

more information, please refer to the power supply installation manual.

Page vii of 110 IQ-400 Installation Manual 33-10057-001-C

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 124 125

Sem comentários

Sharp IQ-8000 Manual de Instalação Página 20