Sharp SF-1020 Manual de Serviço descarregar pdf (Página 65)

6-2. Waste toner bottle replacement (required when

waste toner full detection/maintenance)

1 Take out the process unit as shown above,

<Note> If the unit is removed by holding the toner transport pipe,

toner is spilled. Avoid this.

2 Remove the bottle cover. (2 screws)

3 Rotate waste toner bearing 1 A 90 degrees counterclockwise.

Hole the base of toner transport pipe B and pull it out. (At this

time, toner may be spilled. Put a sheet under the pipe.

4 While pushing waste toner bottle in the direction of A and lift it

and remove.

(Note for assembly/maintenance)

As shown in the figure below, attach so that two projections of

gear 19T g are on the rear frame side (on the screws supporting

plate f side).

2 Replace the waste toner bottle when waste toner full is detected

or at 50K maintenance. At this time, clean and remove the waste

toner from waste toner pipe A.

6 – 18

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 139 140

Sem comentários

Sharp SF-1020 Manual de Serviço Página 65