Sharp PN-TPCi7W7 Guia do Utilizador

PN-TPCi7W7 User Guide Version – 1

Installation 9 Rear Connector Layout Audio Port 2-Channel 4-Channel 5.1-Channel Blue Line-In Line-In Line-In Gre

Installation 10 Rear Connector Layout (con’t) 1. Power Connection (refer to the figure in the previous page) Use only the AC power adapter suppli

Installation 11 How to Recover to Factory Installed Condition 1. Before beginning Make sure that all the data including contents and programs you

End 12 Support & RMA Warranty service is available from a Sharp® Authorized Service Center located in the United States. To receive repair han

Getting Started 1 Getting Started Introduction to PN-TPCi7W7 The PN-TPCi7W7 is a full-featured High Definition PC based upon Intel H67® architectur

Getting Started 2 Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Clas

Specifications 3 Specifications  Chipset o Intel® H67  Size o Mini-ITX form factor o Case: 7.5” x 7.4” x 1.75”  Microprocessor support o

Specifications 4 Specifications (con’t)  On board RealTek™ 8111E Gigabit LAN Chip o Supports 10/100/1000Mbps operation o 1 x RJ45 LAN Port 

Specifications 5 Specifications (con’t)  Optional o Watchdog timer  Environmental o Operating Temperature: 0° to 40° C o Operating Humidi

Installation 6 Mounting PN-TPCi7W7 on Sharp PN-L Series Displays 1. Before beginning Make sure to turn off the monitor and remove the AC power. 2

Installation 7 4. Set the AC power adapter in place Place the AC power adapter into the holder on the right side of the mounting plate as in Figure

Installation 8 There are two fingers on the left side of the mounting plate to catch the PN-TPCi7W7 in place as shown in Figure 6, and they nee