Sharp R-4A55 Manual do Operador descarregar pdf (Página 28)

Drive Shaft

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull exible cable from the drive shaft housing, wipe clean and

recoat with a thin coating[15 ml (1/2 oz.)] of grease.

3. Slide the exible cable back in the drive housing. DO NOT get

dirt on the ex cable.

4. Install the gear housing and shield assembly.

IMPORTANT

Flat edge of washers (D) must be against drive shaft.

lubrIcatIon

Level 1.

Parts Required: POWER BLENDX

8 oz. (P/N 91014) or Lithium

Base Grease.

Gear Housing

1. Clean all loose debris from gear box.

2. Remove plug (A) and check level of grease. Grease should ll gear

case to bottom of grease plug hole.

3. Add grease if necessary using manual grease gun or squeeze-type

tube. Do not use high pressure grease gun. DO NOT over-ll.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Sem comentários

Sharp R-4A55 Manual do Operador Página 28