
CARE AND CLEANING
19
CAUTION: DO NOT USE COMMERCIAL
OVEN CLEANERS, STEAM CLEANERS,
ABRASIVE, HARSH CLEANERS, ANY
THAT CONTAIN SODIUM HYDROXIDE OR
SCOURING PADS ON ANY PART OF YOUR
MICROWAVE OVEN.
CLEAN THE OVEN AT REGULAR INTERVALS
AND REMOVE ANY FOOD DEPOSITS -
Keep the oven clean, or the oven could
lead to a deterioration of the surface.
This could adversely affect the life of
the appliance and possibly result in a
hazardous situation.
Oven exterior
The outside of your oven can be cleaned easily
with mild soap and water. Make sure the soap is
wiped off with a moist cloth, and dry the exterior
with a soft towel.
Control panel
Open the door before cleaning to de-activate the
control panel. Care should be taken in cleaning the
control panel. Using a cloth dampened with water
only, gently wipe the panel until it becomes clean.
Avoid using excessive amounts of water. Do not
use any sort of chemical or abrasive cleaner.
Oven Interior
1. For cleaning, wipe any splatters or spills with a
soft damp cloth or sponge after each use while
the oven is still warm. For heavier spills, use a
mild soap and wipe several times with a damp
cloth until all residues are removed. Do not
remove the waveguide cover.
2. Make sure that mild soap or water does not
penetrate the small vents in the walls which may
cause damage to the oven.
3. Do not use spray type cleaners on the oven
interior.
Keep the waveguide cover clean at all times.
The waveguide cover is constructed from a fragile
material and should be cleaned with care (follow
the cleaning instructions above).
NOTE: Excessive soaking may cause disintegration
of the waveguide cover.
The waveguide cover is a consumable part and
without regular cleaning, will need to be replaced.
Turntable and Roller stay
Remove the turntable and roller stay from the oven.
Wash the turntable and roller stay in mild soapy
water. Dry with a soft cloth. Both the turntable and
the roller stay are dishwasher safe.
Door
To remove all trace of dirt, regularly clean both sides
of the door, the door seals and adjacent parts with
a soft, damp cloth. Do not use abrasive cleaner.
NOTE: A steam cleaner should not be used.
SERVICE CALL CHECK
Please check the following before calling for service.
1. Power Supply
Check the power plug is properly connected to a suitable wall outlet.
Check the line fuse/circuit breaker is functioning properly.
2. Place a cup of water (approx. 150 ml) in the oven and close the door securely.
Programme the oven for one minute on 100 P power and start the oven.
Does the oven lamp come on? YES NO
Does the turntable rotate? YES NO
NOTE: The turntable turns in either direction.
Does the ventilation work?
(Place your hand over the ventilation openings and check for air flow.) YES NO
After 1 minute does the signal sound? YES NO
Does cooking in progress indicator go off? YES NO
Is the cup with water warm after the above operation? YES NO
If you answer “No” to any of the above questions, call a Service Technician appointed by SHARP and report
the results of your check. See inside back cover for details of address.
NOTE: If you cook the food over the standard time with only 100 P (800 W), the power of the oven will lower
automatically to avoid overheating. (The microwave power level will be reduced).
Cooking Mode
Microwave 100 P
Standard time
20 minutes
R-240 English.indd 14R-240 English.indd 14 09.10.27 6:15:48 PM09.10.27 6:15:48 PM
Comentários a estes Manuais