Sharp VC-488NS Manual de Serviço descarregar pdf (Página 20)

Chapter 2 - Installation

Installation

Installing a basic system will require the following:

Mounting of the antenna and the 2 lightning arrestors

 Connecting a power supply to the GPS Receiver

 Interconnecting the antenna, the 2 lightning arrestors, the GPS

Receiver, and a PC.

 Connecting the Command Channel and CDU ports to a PC.

 Installing the TSIP compatible Software to the PC.

Figure 2-1: Alvarion GPS Timing Receiver - Back

Antenna Mounting

The antenna supplied is of the active type, and is suitable for almost all

applications. It is supplied with a pre-attached, 1-meter RG58 cable,

terminated with a male TNC connector. Before commencing

installation, check that all the items detailed in the contents list have

been supplied. The antenna is supplied with two O-type mounting

clamps for attachment to a mounting pole. Figure 2-2 shows an

example of how this might be achieved.

When mounting the antenna, ensure the antenna has a clear view of

the horizon and is at least 2 meters away from transmission sources

which may interfere with reception. Avoid the direct path of any

microwave links. Using the C-MAP software and the GTU check that the

S/N ratio is at least 33.dB and that at least 4 satellites are in view with

this minimum S/N signal. If you do not get these results check another

antenna position.

GPS Timing Receiver Installation and Operation Manual

2-2

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 66 67

Sem comentários

Sharp VC-488NS Manual de Serviço Página 20