Sharp PC-9800T Especificações descarregar pdf (Página 48)

Installing and Uninstalling the Floppy Disk Drive

After installing or uninstalling the floppy disk drive, you have to change the settings

as follows.

After installing the floppy disk drive:

1. Turn on the notebook.

2. When the message Press <F2> to enter SETUP appears, press F2.

3. In the Main menu, set the item of Diskette A: to 1.44 MB, 3 1/2.

4. Press Esc; then, Enter twice. The system restarts.

5. From the Start menu, select Settings - Control Panel.

6. Double-click System, and select the Device Manager tab.

7. Double-click Floppy disk controllers.

8. See whether an X mark is attached to Standard Floppy Disk Controller. If the

mark is not attached, the settings are finished. If the mark is attached, go on to

the next step.

9. Double-click Standard Floppy Disk Controller.

10. Uncheck Disable in this hardware profile.

11. Click OK; then, Yes.

After uninstalling the floppy disk drive:

1. Turn on the notebook.

2. When the message Press <F2> to enter SETUP appears, press F2.

3. In the Main menu, set the item of Diskette A: to Not Installed.

4. Press Esc; then, Enter twice. The system restarts.

Basic Operations 2-9

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 124 125

Sem comentários

Sharp PC-9800T Especificações Página 48