Sharp CD-CH1000 Manual de Serviço descarregar pdf (Página 61)

Reassembly

62 690 01 Rev. C KohlerEngines.com

Install Camshaft

1. Liberally apply camshaft lubricant to each cam lobe.

Lubricate camshaft bearing surfaces of crankcase

and camshaft with engine oil.

2. Position timing mark of crankshaft gear at 12 o’clock

position.

3. Slide camshaft into bearing surface of crankcase,

positioning timing mark of camshaft gear at 6 o’clock

position. Make sure camshaft gear and crankshaft

gear mesh, with both timing marks aligned.

Determining Camshaft End Play

1. Place a new closure plate gasket into position on

crankcase.

2. Position camshaft end play checking tool over

camshaft. Use a feeler gauge to check end play

between camshaft and end play checking tool.

Camshaft endplay should be between 0.3/1.3 mm

(0.011/0.051 in.).

3. No shim is typically used from factory. However, if

camshaft end play is not within speciﬁ ed range,

remove checking tool and shim as necessary.

Breather/Closure Plate/Oil Reservoir Components

A Closure Plate B Gerotor Gears C Oil Pump O-Ring D Oil Pump Housing

E Relief Valve Bafﬂ e F Pickup Tube G Clamp H Inlet Seal

I Pickup Screen J Oil Reservoir K Drain Plug L Gasket

Crankshaft Bearing

(PTO)

N Closure Plate Gasket O Dipstick P Dipstick Tube

Q Breather Assembly R Breather Gasket S Filter T Breather Hose

U Lifting Strap V Oil Seal

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 75 76

Sem comentários

Sharp CD-CH1000 Manual de Serviço Página 61